Filter
Top Products
4
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press* the
LOCK button on your OEM Keyless Entry Remote Control. The horn
will “chirp” twice
†
and the parking lights will flash twice, indicating the
system is armed. The status indicator (red warning light on the dash)
will blink steadily, once per second.
Pre-arm Mode
If the horn chirps and the parking lights flash only once, this indicates
that the vehicle courtesy light is on, or that an entrance is not closed
securely. Check to see that doors, hood, and trunk are properly
closed. Once all entrances are secured (and the courtesy light is off),
the system will chirp / flash again. The system is now fully armed. (If
the entrance is not secured within 4 minutes, the system will arm and
ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system, press the UNLOCK button on your OEM
Keyless Entry Remote Control. The siren will chirp and the parking
lights will flash once.
Attempted Intrusion Identification
If the horn chirps four times when disarming, this indicates that the
system was triggered in your absence. The status indicator will also
flash rapidly. Perform the following operation to determine the protected
zone that triggered the system:
After disarming, press the emergency override button.
The siren will chirp to indicate
the cause of the alarm trigger:
Using Your Existing Remote Transmitter
Existing Keyless Entry or Security Remote
1 chirp IT-s Interior Theft Sensor
2 chirps Door
3 chirps Hood
4 chirps Trunk/Optional Sensors
5 chirps Ignition was turned on
13
CODE-ALARM, INC. Theft Protection Plan
The Theft Protection Program is designed to provide the retail pur-
chaser of a security system provided by CODE-ALARM, INC. (“CODE”)
an additional benefit, at no additional cost to the purchaser, should
their vehicle be stolen while protected by a CODE-ALARM security
system. While CODE has created this program as a way of showing
appreciation to its customers, CODE RESERVES THE RIGHT TO
UNILATERALLY CHANGE, ALTER, MODIFY, OR DISCONTINUE ALL
OR PART OF THIS THEFT PROTECTION PROGRAM WITHOUT
PRIOR NOTICE. THIS THEFT PROTECTION PROGRAM IS NOT AN
INSURANCE POLICY AND SHOULD NOT REPLACE AN AUTOMO-
BILE OR HOMEOWNERS INSURANCE POLICY. THIS THEFT PRO-
TECTION PROGRAM DOES NOT COVER LOSSES ARISING FROM
THE THEFT OF ITEMS WITHIN THE AUTOMOBILE OR ANY DAM-
AGES ARISING FROM, RELEATED TO, AND/OR INCIDENTAL OR A
CONSEQUENCE OF A VEHICLE THEFT EXCEPT AS SPECIFICALLY
DELINEATED BELOW.
Plan duration: 1Year from the date of installation.
Plan amount: F30/F35 ....................Maximum allowable value equal to
insurance deductible or up to $2,500 whichever is less
Conditions of the Theft Protection Program:
1. The Theft Protection Program is non-transferable and non-assignable.
2. The system must be installed by an authorized CODE dealer.
3. Vehicle must be less than three (3) model years old at the time of
installation.
4. The security system must have been fully armed at the time of the vehicle
theft.
5. The vehicle in which the system is installed must be insured for theft by a
licensed insurance underwriter in the state in which the vehicle is
registered.
Terms of payment:
1. The vehicle must first be considered a total loss due to theft by your
insurance company.
2. Your insurance company has settled all claims arising from this theft and
there are no other pending legal actions as a result of this theft.
How to file a request for payment:
If the above conditions are met, make your request for payment by submitting
the following to CODE. The request for payment must be received by CODE no
later than sixty (60) days after the vehicle is reported stolen.
1. Copy of the retail sales receipt for the purchase of the security system,
clearing showing the model of system purchased and the year, make and
model of the vehicle in which the system was installed.
2. A copy of the police report for the stolen vehicle.
3. A copy of the paid insurance claim and reimbursement check from the
insurance company.
Send the above items to CODE by certified mail at the following address:
CODE-ALARM, INC.
Consumer Affairs Department
950 E. Whitcomb
Madison Heights, MI. 48071
1-800-421-3209