Filter
Top Products
21
Getting Started
R
Getting Started
PAIRING YOUR PHONE
Before use, your mobile phone must be
connected or paired with the vehicle’s
Bluetooth system.
Vehicles with touch-screen
Follow these steps to pair your phone
with the vehicle:
•
Switch the vehicle’s ignition ON
(position II).
•
Press the button, to the left of the
touch-screen.
•
Using the touch-screen keypad, enter
the code ##3#*#, then touch .
•
The message Discover Me will be
displayed, to confirm that the system
is ready to pair with a mobile phone.
•
Switch on your mobile phone’s
Bluetooth connection, using the
phone’s menu. (See your phone’s
manual for more information.)
•
Select search for other Bluetooth
devices or Audio Accessories from
your mobile phone’s menu.
•
Select Jaguar in your phone’s paired
device list, in order to connect to the
vehicle’s Bluetooth system.
•
Enter the Passkey on your mobile
phone (the Passkey is 1313).
•
Under certain circumstances, the
message No BT Phone may be
displayed briefly.
•
After a short delay, the message
Phone Connected will confirm that
the phone and vehicle are paired.
Note:
•
Once a mobile phone has been paired
with the vehicle, the system will look
for the same phone each time the
ignition is switched ON. If no phone is
detected, the message No BT Phone
will appear on the touch-screen to
confirm that no phone is connected
after approximately three minutes.
•
When a mobile phone is paired to the
vehicle and the Bluetooth connection
is established, one bar will be
displayed next to the antenna icon.
However, you will need to refer to your
mobile phone’s display to determine
the strength of the network signal.
•
If an incorrect Passkey is entered, your
mobile phone should prompt you to
enter the correct Passkey.
•
If there is a delay of approximately five
minutes when pairing a phone with the
vehicle, a screen with the message
Handset In Use may be displayed. If
this occurs, switch the vehicle ignition
to OFF and wait for at least five
minutes before repeating the pairing
procedure.