Jaguar 2000 Automobile User Manual


 
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input D Serial and Encoded Data B+ Battery Voltage kHz Frequency x 1000
O Output C CAN (Network) V Voltage (DC) ms Milliseconds
SG Signal Ground S SCP Network Hz Frequency mV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, grounds, control
modules and control module pins.
DATE OF ISSUE: October 1999
Fig. 11.1
COMPONENTS
Component Connector / Type / Color Location / Access
AUTO TILT SWITCH (COLUMN SWITCHGEAR) SC9 / 8-WAY GROTE AND HARTMAN MDK / BLACK COLUMN SWITCHGEAR
BODY PROCESSOR MODULE FC15 / 14-WAY AMP EEEC / GREY BULKHEAD / BEHIND GLOVE BOX
COLUMN JOYSTICK (COLUMN SWITCHGEAR) SC9 / 8-WAY GROTE AND HARTMAN MDK / BLACK COLUMN SWITCHGEAR
DOOR CONTROL MODULE – DRIVER DD10 / 22-WAY FORD 2.8 TIMER / BLUE DOOR CASING / TRIM PANEL
DD11 / 22-WAY FORD 2.8 TIMER / BLACK
DOOR CONTROL MODULE – DRIVER REAR RD10 / 22-WAY FORD 2.8 TIMER / BLUE DOOR CASING / TRIM PANEL
RD11 / 22-WAY FORD 2.8 TIMER / BLACK
DOOR SWITCH – DRIVER DD3 / 13-WAY ECONOSEAL III LC / BLACK DOOR CASING / TRIM PANEL
IGNITION SWITCH (KEY-IN SWITCH) FC4 / 8-WAY MULTILOCK 070 / WHITE STEERING COLUMN
MEMORY SWITCHES DD1 / 26-WAY AMP MICRO QUAD LOCK / YELLOW DOOR TRIM PANEL
(DRIVER DOOR SWITCH PACK)
NOT-IN-PARK MICROSWITCH CC13 / 3-WAY MULTILOCK 070 / WHITE CENTER CONSOLE ASSEMBLY
STEERING COLUMN MOTORS FC49 / 6-WAY MULTILOCK 070 / WHITE STEERING COLUMN
FC50 / 8-WAY MULTILOCK 070 / YELLOW
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color Location / Access
CA8 20-WAY MULTILOCK 070 / WHITE DRIVER ‘A’ POST / DOOR HARNESS GAITER
CA10 8-WAY MULTILOCK 070 / YELLOW DRIVER ‘A’ POST / DOOR HARNESS GAITER
CA13 4-WAY MULTILOCK 070 / WHITE DRIVER ‘B/C’ POST / DOOR HARNESS GAITER
CA14 6-WAY MULTILOCK 070 / WHITE DRIVER ‘B/C’ POST / DOOR HARNESS GAITER
FC7 20-WAY MULTILOCK 070 / YELLOW ABOVE DIMMER MODULE / COIN TRAY
GROUNDS
Ground Location / Type
CA33L EYELET (PAIR) – RH ‘A’ POST GROUND SCREW
CA36L EYELET (PAIR) – LH ‘A’ POST GROUND SCREW
CC3L EYELET (PAIR) – RH FRONT BULKHEAD STUD / CABIN SIDE
FC17L EYELET (PAIR) – EMS BULKHEAD GROUND STUD
FC17R EYELET (PAIR) – EMS BULKHEAD GROUND STUD
FC29L EYELET (PAIR) – LH BULKHEAD GROUND STUD / CABIN SIDE
FOR CONTROL MODULE PIN OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Pin Description Active Inactive
I FC15-11 AUTO TILT REQUEST GROUND B+
I FC15-15 IGNITION SWITCHED GROUND GROUND B+
I FC15-25 GROUND SUPPLY GROUND GROUND
I FC15-32 IGNITION SWITCHED GROUND GROUND B+
O FC15-40 COLUMN MOTOR POTENTIOMETER REFERENCE VOLTAGE 5V
I FC15-41 STARTER ENGAGE REQUEST GROUND (CRANKING) B+
O FC15-52 COLUMN REACH MOTOR SUPPLY B+ GROUND
I FC15-58 NOT IN PARK MICROSWITCH STATUS GROUND (PARK) B+ (NOT IN PARK)
I FC15-66 COLUMN REACH MOTOR POTENTIOMETER FEEDBACK 0.5 V = OUT, 4 V = IN
I FC15-67 KEY IN IGNITION GROUND (KEY IN) B+ (KEY OUT)
O FC15-78 COLUMN REACH MOTOR SUPPLY B+ GROUND
I FC15-80 BATTERY SUPPLY VOLTAGE B+ B+
S FC15-84 SCP NETWORK 2 – 1600 Hz
S FC15-85 SCP NETWORK 2 – 1600 Hz
I FC15-87 COLUMN MOVEMENT REQUEST UP = 10.1V, DOWN = 12.1V, RETRACT = 8.5V, EXTEND = 6.8V
O FC15-90 COLUMN TILT MOTOR POTENTIOMETER REFERENCE GROUND GROUND GROUND
O FC15-91 COLUMN REACH MOTOR POTENTIOMETER REFERENCE GROUND GROUND GROUND
I FC15-93 COLUMN TILT MOTOR POTENTIOMETER FEEDBACK UP = 4V, DOWN = 0.5V
O FC15-99 COLUMN TILT MOTOR SUPPLY B+ GROUND
O FC15-100 COLUMN TILT MOTOR SUPPLY B+ GROUND
I FC15-102 BATTERY SUPPLY VOLTAGE B+ B+
DRIVER DOOR CONTROL MODULE
Pin Description Active Inactive
I DD10-1 BATTERY POWER SUPPLY B+ B+
I DD10-8 LOGIC GROUND GROUND GROUND
S DD10-9 SCP NETWORK 2 – 1600 Hz
S DD10-16 SCP NETWORK 2 – 1600 Hz
O DD11-2 SEAT MEMORY STATUS LED GROUND (LED ON) B+
I DD11-20 DRIVER DOOR SWITCH GROUND (DOOR OPEN) B+
DRIVER REAR DOOR CONTROL MODULE
Pin Description Active Inactive
I RD10-1 BATTERY POWER SUPPLY B+ B+
I RD10-8 LOGIC GROUND GROUND GROUND
S RD10-9 SCP NETWORK 2 – 1600 Hz
S RD10-16 SCP NETWORK 2 – 1600 Hz
I RD10-19 MODULE IDENTIFICATION GROUND GROUND
I RD11-5 MEMORY 1 B+ GROUND
I RD11-7 MODULE IDENTIFICATION GROUND GROUND
I RD11-13 MEMORY SET B+ GROUND
I RD11-15 MEMORY 3 B+ GROUND
I RD11-22 MEMORY 2 B+ GROUND
NOTE: Refer to the Appendix at the rear of this book for CAN and SCP Network messages.