Filter
Top Products
10
Volkswagen ISVW532
Operation
Selecting AUX
Press the “CD” button twice to switch the radio to the CD Changer source.
This will access “AUX1”.
Selecting between AUX1 / AUX2
To select “AUX2” press preset #2. To select “AUX1” press preset #1.
Symptom Cause Remedy
Radio shows
“DEV INIT”
PXAUX device is
initializing.
This only occurs the rst time the
PXAUX is powered on. Wait a few
minutes, cycle ignition off and on then
enter SAT mode.
Radio does
not recognize
module.
Dipswitches are
not set properly
or the unit did not
initialize properly.
See connection diagram for proper
dipswitch setting. If the dipswitches
are set properly disconnect the 24 pin
micro-t connector from the PXAUX for
5 minutes to reset the interface.
No sound. Auxiliary cable
is not connected
to accessory or
PXAUX.
Verify that the auxiliary cable is
connected to the PXAUX and the
accessory.
Troubleshooting
CD Changer Mode
Selecting AUX
Press the “DISC” or “AUX” button to switch to CD Changer mode. You are
now in the AUX1 mode.
Selecting between AUX1 / AUX2
If you are currently in “AUX1” or “AUX2” mode press the “DISC ▲” button to
cycle between AUX1” & “AUX 2” .