Filter
Top Products
LM2350E-X
PAGE2OF4
PARTS LIST / LM2350E–XX
ITEM DESCRIPTION (Size in Inches)
QTY
PART NO. [MTL] ITEM DESCRIPTION (Size In Inches)
QTY
PART NO. [MTL]
1 Carriage Bolt (1/4" - 20x 9" long) (4) 94333 [C]
2 Upper Cap (1) 94390 [Z]
n3 Track Gasket (2) 94392 [B]
4 Sleeve (2) 94316 [Br]
n5 ``O" Ring (1/16" x11/16" o.d.) (4) Y325-15 [B]
n6 ``O" Ring (1/8" x 3/4" o.d.) (4) Y325-206 [B]
7 Spool (2) 94310 [D]
n8 ``U" Cup (1/8" x 3/4" o.d.) (2) Y240-7 [B]
n9 ``O" Ring (.106" x .587" o.d.) (2) 15066 [B]
10 Cylinder (1) 94306 [A]
11 Adapter (1) 94384 [C]
n13 ``O" Ring (1/16" x 7/16" o.d.) (1) Y325-11 [B]
14 Muffler Housing (1) 94443 [A]
15 Foam Liner (2) 94402
16 Edge Trim (2) 94378-1 [N]
18 Retaining Ring (1) 94406 [C]
19 Washer (1) 94515 [C]
n20 ``U" Cup (3/16" x 3"o.d.) (2) 94518 [B]
21 Piston (1) 94403 [D]
22 Lower Cap (1) 94391 [Z]
23 Piston Adapter (1) 94388 [C]
n24 ``O" Ring (3/32" x 1" o.d.) (1) Y325-117 [B]
25 Dowel Pin (1/4" o.d. x 7/8" long) (1) Y148-37 [C]
n26 ``O" Ring (1/8" x 1-9/16"o.d.) (1) Y325-219 [B]
n27 ``O" Ring (3/32" x11/16" o.d.) (1) Y325-112 [B]
28 Bushing (1) 94374 [C]
n29 Rod Seal (1) 93921 [U]
30 Base -LM2350E-X1 (1) 94536 [C]
-LM2350E-X2 (1) 94536-1 [C]
31 Nut (1/4" -20) (4) 93828 [SS]
32 Ground Screw (#10 -32 x1/4") (1) 93005 [C]
n33 Gasket (1) 70834 [Co]
34 Extension Tube
- LM2350E-2X(7.531'')
(1) 94401-2 [C]
- LM2305E-3X(20.281'') (1) 94401-3 [C]
- LM2305E-4X(28.781'') (1) 94401-4 [C]
- LM2305E-6X(10.281'')
(1) 94401-6 [C]
n35 Gasket (1) 70837 [Co]
36 Piston Rod (1) 94385 [C]
37 Connecting Pin (1) 90274 [C]
n38 Cotter Pin (1/16" x1/2" long) (1) Y15-21 [C]
39 Connector- LM2350E-2X(3.457") (1) 94340-2 [C]
- LM2350E-3X(16.207") (1) 94340-3 [C]
- LM2350E-4X(24.707") (1) 94340-4 [C]
- LM2350E-6X(6.207")
(1) 94340-6 [C]
Piston &Tube Ass'y(includes40-44)
(1) 71523
40 Lower Suction Tube (1) [C]
41 Plunger (1) [C]
42 Ball Stop (1) 83276 [C]
43 Ball (9/32" dia.) (1) Y16-209 [C]
44
Adapter (1) 70817 [C]
n45 Guide Washer (1) 71524 [Co]
46 Spacer (1) 72392 [C]
47 Retaining Ring (.763" o.d.) (1) Y147-68 [C]
48 ``U" Cup (3/16" x11/16" o.d.) (1) Y186-4 [B]
49 Guide Spacer (1) 76705 [T]
50 Valve Body (1) 76704 [SH]
n
Foot Valve Ass'y (includes 47-50) (1) 60940
n51 Gasket (1) F21-65 [Co]
52 Valve Seat (1) 6797 [C]
53 Primer Rod (1) 94446 [C]
n54
Retainer Ring (1) 94397 [C]
55 Primer (1) 94400 [C]
56 Primer Tube (1) 94399 [C]
: 57 Bung Assembly (includes 58) (1) 67145-2 [ZA]
: 58 Thumb Screw (1/4" -20 x 1") (3) Y66-59-C [C]
:
Items 57,58notwith -6Xmodels
n
Parts in Repair Kit 637227
OPERATING
AND SAFETY PRECAUTIONS
WARNING
EXCESSIVE INLET PRESSURE. Can cause exĆ
plosion resultinginsevereinjuryordeath. DonotexceedmaxĆ
imum operating pressure of7500 psi (517 bar)at 150 psi (10.3
bar)inletairpressure. DonotrunpumpwithoutusingaregulaĆ
tor to limit air supply pressure to the pump.
WARNING
EXCESSIVE MATERIAL PRESSURE. Can cause
equipment failure resulting in severe injury or property damĆ
age. Do not exceed the maximum material pressure of any
component in the system.
Replacement warning label is available upon request,PN \94520.
PUMPRATIO X
INLETPRESSURETOPUMP MOTOR
=
MAXIMUMPUMP
FLUIDPRESSURE
Pumpratioisanexpression oftherelationshipbetweenthepumpmotorareaand
thelowerpumpend area.EXAMPLE:When150 p.s.i.(10.3bar)inlet pressureis
suppliedtothemotorofa50:1 ratiopumpitwilldevelopamaximumof7500p.s.i.
(517 bar)fluid pressure(at noflow)- asthe fluidcontrol isopened, the flowrate
will increase asthe motor cycle rateincreases to keep upwith the demand.
NOTICE: Thermal expansioncan occur when the fluidin the mateĆ
rial lines is exposed to elevated temperatures. Example: Material
lines locatedina non-insulatedroofareacan warmdueto sunlight.
Install a pressure relief valve in the pumping system.