Filter
Top Products
Engine Oil
26
Figure 19 Remove Engine Oil Filter
27
Figure 20 Coat Rubber Seal
4. Use a clean, lint-free rag to wipe the oil lter port ange surface clean where the oil lter gasket seats.
5. To help seal the new oil lter to the oil port ange, apply a light coat of white lithium NLGI Number 2 grease (Dow
Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside surface of the lter
before attaching it to the oil lter port (Figure 20). Install the new oil lter (P/N 603 00 00-41) onto the engine oil
lter port. See following NOTE.
NOTE: Use only Husqvarna oil lters designed for your engine.
6. Tighten the oil lter by hand 2/3 turn after gasket contact. Do not use a band wrench or channel lock pliers.
212
Figure 21 Add Engine Oil
Page 36 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual