Filter
Top Products
Roll-Over Protective Structure and Seat Belts
WARNING
• Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure.
Do not attempt repair.
• The driver and passenger must be restrained at all times with the seat belts provided to help prevent
injury in the event of sudden braking, collision, or roll-over.
• In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated with
seat belt fastened and with arms and legs inside the vehicle.
• After inserting the tab, make sure the tab and buckle are locked and that the belt is not twisted.
• Loose tting seat belts could increase the chance of injury due to sliding under the belt if sudden
braking should occur. Keep the seat belt snug and positioned as low on the hip bone as possible.
• Use a single seat belt for one person at a time. Do not use a single seat belt for two or more people –
this includes children.
• No more than one person per bucket seat at one time. Do not allow people to ride in any part of the
vehicle that is not equipped with a seat and a seat belt. Do not allow a passenger to hold a child in his
or her lap while the vehicle is moving.
• The Husqvarna vehicle is not designed to meet child seat compatibility requirements. Children
requiring a child safety seat must not ride on the vehicle. Comply with state and local laws pertaining
to child safety.
CAUTION
• Be careful not to damage the seat belt webbing or hardware.
• Inspect the seat belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not disassemble or modify the system.
• Keep seat belts clean and dry. If cleaning is necessary, use a mild soap and lukewarm water solution.
Do not use bleach, dye or abrasive cleaners as they may severely weaken the seat belts.
• Do not insert coins, clip, etc. in the buckle as this may prevent the tab from locking into the buckle
properly.
• If the seat belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the seat belt is repaired.
DRIVERS SIDE SEAT CONTROLS
Drivers Side Seat Adjustments
Use the position adjustment lever (1) to move the seat closer to or farther from the steering wheel (Figure 11). To
adjust the seat position, sit in the driver seat and raise the position adjustment lever. Slide the seat either forward or
backward until it reaches the desired position, then return the lever to its original position.
The height adjustment knob (2) enables you to modify the seat height. Use the seat height adjustment together with
the seat tension adjustment until the seat feels comfortable.
To adjust the seat height, sit in the driver seat and pull out the adjustment knob (2). Move the knob toward the shorter
indicator to lower the seat height or toward the taller indicator to raise the seat height.
Seat tension controls how rm or soft the ride feels to the driver. Increasing seat tension results in a rmer ride;
decreasing tension results in a softer ride.
Use the tension adjustment lever (3) to adjust the seat tension. Pull out the tension adjustment handle (3), rotate
the handle to the plus (+) sign to increase tension or the minus (–) sign to decrease tension, and release the handle.
Firmly grasp the handle and move it from side to side to modify the tension adjustment. The tension indicator
(4) moves closer to the larger person when tension is increased and closer to the smaller person when tension is
decreased. See following NOTE.
Page 18 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual