Husqvarna HUV4421GXP Automobile User Manual


 
Controls and Indicators
Page 14 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual
LOW OIL WARNING LAMP
The low oil warning lamp (9) is located on the instrument panel just to the left of the steering column (Figure 4
and Figure 5, Page 11). If the warning lamp lights up, oil should be checked and added to the engine as nec-
essary before vehicle use continues. The vehicle should never be driven when the low oil warning lamp
remains lit. If the warning lamp alternately lights and darkens, the vehicle may be driven, but oil should be
added at the first opportunity. If the oil level is correct and the warning lamp remains lit, have a trained tech-
nician check the vehicle. See following CAUTION.
CAUTION
Failure to add oil immediately when the low oil warning lamp remains lit may result in
permanent engine damage.
FUEL GAUGE/HOUR METER
The fuel gauge and hour meter (8) are housed together on the right side of the instrument panel (Figure 4
and Figure 5, Page 11). The fuel gauge operates when the key switch is in the ON position and allows the
operator to monitor the fuel level in the vehicle. The hour meter operates only when the engine is running, and
should be used by the trained technician to track vehicle usage and determine when periodic service proce-
dures are required. See Periodic Service Schedule on page 29.
HEADLAMP CONTROL
The headlamp control (12) is located on the left side of the instrument panel (Figure 4 and Figure 5, Page
11). Press the headlamp rocker switch to turn the headlamps on or off. See following NOTE.
NOTE: Using the headlamps for extended periods while the engine is either off or idling will discharge the
battery.
ELECTRIC BED LIFT – OPTIONAL ON SOME VEHICLES
The electric bed lift switch (13) is located on the instrument panel to the left of the key switch (Figure 4 and
Figure 5, Page 11). See following NOTE.
NOTE: Remove cargo before raising the bed.
To lift the bed, push up and hold the rocker switch in the upper position. Release the switch to stop the lifting
operation. To close the bed, press down and hold the switch in the lower position. The bed lift will make a loud
clicking sound to signal that the bed is in the rest position.
HIGH-TEMPERATURE WARNING LAMP – DIESEL VEHICLES ONLY
The high-temperature warning lamp (10) is located on the instrument panel to the left of the steering column,
next to the low oil warning lamp (9) (Figure 5, Page 11). The diesel engine is liquid-cooled; if the engine cool-
ant has exceeded its normal safe operating temperature, the warning lamp will illuminate. If the warning lamp
lights up, stop the vehicle and allow it to idle for approximately five minutes before stopping the engine. Con-
tact a Husqvarna dealer/distributor or a trained technician. See following WARNING.
ý WARNING
• Allow the engine to cool before servicing the engine coolant system. Engine coolant can
cause severe burns.