Filter
Top Products
Seat Latch and Adjustment
2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Page 17
SEAT LATCH AND ADJUSTMENT
The vehicle seat(s) are hinged to allow easy access to the engine compartment. To raise the seat bottom,
grasp the rear side of the seat bottom, and pull firmly in a forward/upward direction. See following WARN-
ING.
ý WARNING
• Make sure seat hinges and latches are securely engaged before operating the vehicle.
Vehicles with bucket seat option:
The driver-side bucket seat is adjustable and can be moved forward or backward to accommodate the driver.
To adjust this seat, push the lever located under the driver seat to the left (towards outside of the vehicle).
Position the seat, and return the lever to its original position. See following WARNING.
ý WARNING
• Do not adjust the driver-side seat while the vehicle is in motion.
To adjust the passenger-side seat
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat to achieve the desired seat position.
4. Install washers and bolts, and tighten to 96 in-lb (10.8 N·m).
5. Install the seat. See preceding WARNING “Make sure seat hinges and latch...”
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Husqvarna vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with the controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Figure 8 Adjust Headrests
1