Filter
Top Products
Step 6: Install frame hooks:
Slide long frame hook down
vertical post facing vehicle.
Then slide short frame hook
onto post, facing away from
vehicle. You should hear be able
to hear the spring loaded lever
engaging the teeth on the post
as shown in fig. 8.
Step 6A:
Installing into a 1 ¼” trailer
Fig. 9
Note: The receiver tube comes
ready for installation into a 2”
hitch. If you have a 1 ¼” hitch,
use the provided hex wrench to
remove the plastic spacer as
shown in Fig. 9.
Place lock
washer and flat washer
onto hitch pin bolt as indicated.
Insert the receiver tube into the
hitch. Align the holes, insert the
hitch pin bolt and tighten securely
using a ¾” wrench.
Step 6 B: Installing into a
2”
trailer hitch
Place lock washer and flat washer onto hitch pin
bolt as indicated. Insert the receiver tube into the
hitch. Align the holes, insert the hitch pin bolt
and tighten securely using a ¾” wrench.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Install Hitch pin clip
after tightening bolt
Important! When inserting the hitch pin
bolt, the bolt should pass through the
receiver tube first then through the
plastic spacer.
3
Fig. 8