Filter
Top Products
Assembly & Installation Procedure:
Step 1: Locate holes on main rack assembly,
bracket and hardware (Fig. 1)
Step 2: Loosely assemble bracket to main
rack as shown in Fig. 2 & 3. Bolts (I) inserts
through lock washer (L), then flat washer (J),
then top plate and into bottom plate Do Not
tighten!
Step 3: Slide main rack assembly onto
Receiver tube as shown in Fig. 4 & 5.
Adjust position so that is 3 or 4 inches
between the end of the rack and end of the
receiver tube. Tighten using hex wrench
provided or equivalent. Note: Final position
of vertical portion of the rack can be re-
adjusted after you have installed the rack on
your vehicle
Step 4. Insert “stop bolts” (G) through hole in
receiver tube as indicated.
See Fig. 6.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
washers
Step 5a: Install Wheel holders:
Fig. 7
2
Fig. 6