Filter
Top Products
12
2.6 Nitrous Feed Line Mounting
HINT: Following the fuel lines along the left side of the vehicle and entering the engine bay near the master cylinder works well.
1. Determine the route for your nitrous feed line to follow. Ensure the path is clear of exhaust system, suspension, steering,
wheels, electrical lines and components, and tires.
2. Feed the main nitrous supply line (21) along the proposed route.
3. If it is necessary to support the nitrous supply line under the vehicle, use 1/2” Tinnerman clamps or nylon tie-wraps to
support the line securely.
4. Attach the nitrous supply line to the nitrous bottle valve adapter (2).
WARNING: Nitrous oxide is dangerous to humans if inhaled or comes in contact with the skin. Always point the
nitrous line opening away from people when purging the line.
5. Purge the nitrous supply line.
A. Wrap the end of the nitrous line with a rag and hold securely.
B. Point the opening away from people.
C. Briefly open the bottle valve.
6. Attach the nitrous supply line to the nitrous filter fitting.
2.7 Solenoid/Nozzle Nitrous Line Connection
1. Place the desired jet (17) in each nozzle inlet. See Chapter 3 for tuning suggestions.
2. Connect the straight end of the two 14” x 3AN Hoses (16) to the TEE at the outlet of the nitrous solenoids.
3. Connect the other end of the hoses to the nozzles.
2.8 Electrical System Installation
Use the following procedure and refer to Figures 8 for the electrical system installation.
WARNING! Death or injury may occur from working on a charged electrical system.
1. Disconnect the car battery.
Figure 8 Wiring Schematic