Filter
Top Products
Add shims (ITEM 11) and/or new bearing
plates (ITEM 12 or ITEM 13) when this
movement exceeds 0.060˝ (
1
/
16
˝). See Figures
3 through 6.
B. If shimming is required, shim as follows:
1. Remove shoes and disassemble
Kompensator. See Figure 3.
2. Remove bearing plates (ITEM 12 and
ITEM 13). Measure thickness if less than
.31˝ (
5
/
16
˝) thick. Replace with new
Holland part.
3. Install shims.
4. Check for free lateral movement of shoe
in frame. DO NOT over shim.
Recheck fore and aft movement of the
shoe subassembly. Movement is to be less
than .06˝ (
1
/
16
˝).
C. Inspect the cushions (ITEM 5) and other
components for distortion and splitting or
cracking. If disassembly is required, follow
steps 1–5 under section 4 below, and replace
as required.
4. Kompensator Base Subassembly: Measure
Upward Movement:
A.
Measure upward clearance on the assembly.
Do this on one side at a time by lifting the fifth
wheel top plate upward manually with the aid
of a bar (see Figure 7). Clamp the shoe (ITEM 2)
on the opposite side to prevent its movement,
which will affect the measurement (see Figure
7). If the total movement exceeds 0.5˝ (
1
/
2
˝),
the unit should be disassembled for further
inspection.
If disassembly is required, follow the
steps below:
1. Remove the fifth wheel top plate from
the Kompensator base removing the
appropriate roll pins and bracket
pins or cotter pins, nuts and bolts,
depending upon model.
2. Remove all loose internal parts (shoes,
tie rod, etc.).
3. Inspect all parts for distortion, wear
and cracking. Replace if necessary.
4. Measure the thickness of the curved
base of the shoe sub-assembly
(ITEM 2). The shoe should be replaced if
the base thickness measures less than
0.31˝ (
5
/
16
˝). See Figure 8.
5. Reassemble and lubricate as noted
above. Check for free lateral and
fore-aft movement of the shoe
sub-assemblies after reassembly.
NOTE:
For severe dusty/dirty environments, shoe
dust covers (see Figure 9) are available.
request Holland parts XA-0128-L
and XA-0128-R.
XL-FW208-06 3
Pry or lift one side at a time.
Disassemble if it exceeds 0.5".
FIGURE 7
BEARING
PLATE
SHIM
FIGURE 5 FIGURE 6
Measure shoe base
thickness. Replace if
it is less than .31˝
(
5
/16˝).
SHOE BASE
FIGURE 8
FIGURE 9
DUST COVERS