Filter
Top Products
Page 13SKU 96549
For technical questions, please call 1-800-444-3353.
Measure the Spark Plug electrode gap with a feeler gauge (not supplied). It should be
between 0.7 to 0.8 mm. If adjustment is necessary, bend the side electrode carefully,
then re-measure. If Spark Plug Gasket is damaged, replace it.
Replace Spark Plug by hand for the first few turns, then tighten with the socket wrench
completely. A Spark Plug with a new Gasket requires 1/2 more turns to tighten than
the used Gasket which requires 1/8 to 1/4 turns to tighten.
Changing Oil
Run the Engine for five minutes to warm up the oil, then shut off the Engine.
Place a drain pan under the Drain Plug.
Remove the Dip Stick and unscrew the Drain Plug.
Allow all the oil to drain out into the pan. Pour the used oil into a container with a lid.
Deliver used oil to a recycling center. Do not dump oil into the earth or storm drain.
Dispose of oil properly.
Replace Drain Plug and securely tighten.
Add 1/2 quart of 10W30 motor oil through a funnel (not included) into the Dip Stick fill
hole. Fill until the oil reaches the Upper Level line of the fill hole.
Replace the Dip Stick carefully.
Cleaning the Deposit Cup
Push the Gas Valve to the closed (left) position.
Using a wrench (not supplied), loosen and remove the Bolt
under the Deposit Cup. Place a pan below the Deposit
Cup to catch any remaining gasoline.
Remove the Deposit Cup and O-ring, and wash them in
cleaning solvent.
Reinstall the Deposit Cup.
Push the Gas Valve to the open (right) position and check
for gas leaks from the Deposit Cup. Reinstall the Deposit Cup and tighten hardware.
3.
4.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.