Filter
Top Products
Warning: Be aware when adding wood pieces to corner supports. This Mobile Base,
like any tool has its limitations. Do not overbuild or overload. Always keep in mind
the Weight Capacity and the Base size of the tool you wish to load onto this Mobile
Base.
4. Use 3/8" drill bit (not included) to drill four holes, two one each side of the ends of
“Wood A”. Use the pre-drilled holes located in the sides of the Corner Supports as
guides for where to drill the holes for the Hex Screws. Push one Hex HD Screw (11),
through each hole with the head of the Screw on the inside of the Corner Support (1),
and the Lock Nut (16) on the outside, (Illustration 3).
5. Repeat for each of the four Corner Supports (1).
NOTE: Once assembled, check each of the Corner Supports (1), and all Hex Screws (11),
and Lock Nuts (16) to make sure all parts are assembled correctly and the Mobile Base is
stable. Always check for any damaged or worn parts.
NOTE: Many parts listed and shown are for location illustration only and are not available for
replacement parts.
SKU 95288 For technical questions, please call 1-800-444-3353. Page 4
REV 02/07
“Wood A”