Filter
Top Products
CAUTION: Be aware of dynamic loading. Movement of the Mobile Base under load, or a load
dropping onto the Mobile Base could create a momentary load exceeding the load capacity of
300 LBS., which could result in damage to the Mobile Base, and/or personal injury.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors that cannot be built into this product
but must be supplied by the operator.
UNPACKING
When unpacking, check to make sure all parts listed on page 6 of this manual are included. If any
parts are missing or broken, please call Harbor Freight Tools® as soon as possible.
ASSEMBLY INSTRUCTIONS
1. The Corner Supports (1) will fit wood pieces (not included) of varying lengths,
depending on the size of the tool to be moved. The sides of the wood should measure
1-1/4"W X 1-1/4"H in order to slide into the openings in the Corner Supports (1),
(Illustration 1).
(Illustration 1)
2. Mobile Base length would be the length of the tool to which it is to be attached, minus
1-3/4". This is known as, “Wood-A”, (not included), (Illustration 2).
3. Mobile Base width would be the width of the tool to which it is to be attached plus 5/8".
This is known as, “Wood-B”, (not included), (Illustration 2).
(Illustration 2)
SKU 95288 For technical questions, please call 1-800-444-3353. Page 3
REV 02/07