Filter
Top Products
SKU 94318 For technical questions, please call 1-800-444-3353 PAGE 7
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Laser Guided Parking System is unplugged
from its electrical outlet prior to performing any inspection, maintenance, or
cleaning of the machine.
2. Daily, inspect the general condition of the Laser Parking System. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect the safe op-
eration of this product. If abnormal noise occurs, have the problem corrected
OPERATING INSTRUCTIONS
1. Open the garage door using the automatic garage door opener and drive in
slowly.
2. The laser light beam will move toward you across the vehicle’s hood as you drive
into the garage.
3. Stop and park when the laser light beam reaches the location on the vehicle you
previously selected (hood, dashboard, etc.).
4. The Laser Guided Parking System is automatically activated by your garage door
opener. The laser beam(s) will automatically deactivate when the garage door
opener light turns off (typically after about 3 minutes).
TROUBLESHOOTING
Problem Possible Solution
Garage door opener operates, but
Laser Guided Parking System does
not automatically activate.
1. Make sure the Pull Chain on the AC
Adapter with Pull Chain is pulled to
its “ON” position.
2. Make sure the AC Adapter with Pull Chain
is firmly screwed into the garage door
opener light socket.
3. Make sure the Power Pack is firmly
connected to the AC Adapter with Pull
Chain.
4. Make sure the Cable of the Laser Guided
Parking System is properly connected to
the Swivel Mount and Power Pack.
When parking a vehicle, other than
the vehicle typically parked, the laser light
beam does not illuminate the previously
selected location (hood, dashboard, etc.) on
the vehicle.
1. The Swivel Mount must be re-adjusted,
depending on the specific type (make and
model) of the new vehicle being parked.