Filter
Top Products
(Due to continuing improvements, actual product may differ slightly from the product described herein.)
NOTE: Some parts are listed and shown for illustration purposes only, and are not
available individually as replacement parts.
SKU 93861 For technical questions, please call 1-800-444-3353 PAGE 3
Trailer Light Mounting And Connection:
1. Mount the Stop-Tail-Turn Light (1), marked “L.H.” (with the License Window), on the left rear of the
trailer with its side marker to the outside of the trailer. Then, mount the License Plate Bracket (3) with the
Stop-Tail-Turn Light. (See Assy. Diagram.)
2. Mount the Stop-Tail-Turn Light (1), marked “R.H.” (without the License Window), on the right rear of
the trailer with its side marker to the outside of the trailer. (See Assy. Diagram.)
3. Use the Metal Frame Clips included in the Mounting Hardware Package (6) to mount each half of the
Split Y-Style Harness (4) down each side of the trailer. Run the YELLOW and BROWN wires down the
left side and GREEN and BROWN wires down the right side of the trailer. (See Assy. Diagram.)
4. Connect the YELLOW and BROWN wires to the left hand Stop-Tail-turn Light (1) with the Wire Nut
Connectors included in the Mounting Hardware Package (6). (See Assy. Diagram.)
5. Connect the GREEN and BROWN wires to the right hand Stop-Tail-turn Light (1) with the Wire Nut
Connectors included in the Mounting Hardware Package (6). (See Assy. Diagram.)
6. Attach the WHITE GROUND wire to the trailer tongue or frame. (See Assy. Diagram.)
7. Mount the two Marker Clearance Lights (2) in the areas shown in the illustration. Connect each wire
from the Marker Clearance Lights to the BROWN wire on each half of the Split Y-Style Harness (4).
(See Assy. Diagram.)
8. Connect the Split Y-Style Harness (4) Plug to the Color Coded Trunk Harness (5) Plug.
(See Assy. Diagram.)
9. Turn on the towing vehicle’s headlights. The two Stop-Turn-Tail Lights (1) and two Marker Clearance
Lights (2) should turn on. The brighter Stop Lights should turn on only when the vehicle’s brake pedal is
depressed, or when the vehicle’s turn signal is activated (ignition key must be in its “on” position).
10. If the Light Kit fails to illuminate, check all ground connections. If the turn signals on the Light Kit do
not illuminate, check the connections between the towing vehicle’s wiring and the Color Coded Trunk
Harness (5). (See Assy. Diagram.)
1
1
2
2
3
4, 5
6
Maintenance
Monthly check wiring for deterioration; screws for tightness and that bulbs are not burned out.
Replace all problems.
Part # Description Qty Part # Description Qty
1 Stop-Tail-Turn Light 2 4 Split Y-Style Harness 1
2 Marker Clearance Light 2 5 Color Coded Trunk Harness 1
3 License Plate Bracket 1 6 Mounting Hardware (1 package) 1