Harbor Freight Tools 93861 Automobile Parts User Manual


  Open as PDF
of 4
 
ASSEMBLY INSTRUCTIONS
Vehicle Connection:
1. Connect the BROWN wire of the Color Coded Trunk Harness (5) to the towing vehicle’s Tail Light wire.
Connect the YELLOW wire of the Color Coded Trunk Harness to the vehicle’s Left Hand Stop & Turn
light. Connect the GREEN wire of the Color Coded Trunk Harness to the vehicle’s Right Hand Stop &
Turn light. Make sure to use the BLUE Wire Splitter Connectors to make these connections.
(See Assy. Diagram.)
2. Attach the WHITE GROUND wire to the towing vehicle’s frame. (See Assy. Diagram.)
3. Maintain the Light Kit. Keep the Light Kit clean and dry for better and safer performance.
4. DO NOT submerge the Light Kit in water. This Light Kit is NOT waterproof, and will become seriously
damaged if submerged in water or other liquids. This product is not intended for marine use.
5. If necessary, have a qualied service technician install the Light Kit. Do not attempt to install this
product yourself if you do not feel technically competent to do so.
6. Use the right product for the job. There are certain applications for which this product was designed.
Do not use small equipment or attachments to do the work of larger industrial equipment or attachments.
Do not use this product for a purpose for which it was not intended.
7. If your trailer, camper, etc. is OVER 80” wide: You will need to install three additional Red Marker
Lights (not included) onto the rear of the unit. To do so, mount the three Red Marker Lights to the rear of
the unit, making sure the Lights are no less than 6” and no more than 12” from center of Light to center
of Light. After the Lights are mounted, use wire nut connectors (not included) to connect all three leads
together. Then connect to the Brown wire in the back of one Tail Light (either side) provided in this Kit.
(See Assy. Diagram below.)
8. Replacement parts and accessories: When servicing, use only identical replacement parts. Only use
accessories intended for use with this product.
9. WARNING! People with pacemakers should consult their physician(s) before using this product.
Operation of electrical equipment in close proximity to a heart pacemaker could cause interference to or
failure of the pacemaker.
10. WARNING! The warnings and precautions discussed in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator.
3. NOTE: If the towing vehicle has rear turn signals separated from its stop lights, you will need to install
additional hardware.
L.H. STOP & TURN
(YELLOW)
SPLITTER WIRE CONNECTOR
SIDE MARKER
(AMBER)
SIDE MARKER
(AMBER)
SPLITTER WIRE CONNECTOR
SPLITTER WIRE CONNECTOR
GROUND
(WHITE)
GROUND
(WHITE)
TAIL LICENSE,
SIDE MARKER
(BROWN)
R.H. STOP & TURN
(GREEN)
BROWN
GREEN
YELLOW BROWN
LEFT REAR
&
LICENSE BRACKET
RIGHT REAR
3 REAR MARKERS
(RED)
REQUIRED
FOR TRAILERS
OVER 80” WIDE
(NOT INCLUDED)
SKU 93861 For technical questions, please call 1-800-444-3353 PAGE 2
Note: Connect the Light Kit after the trailer is fully assembled.
REV 07k
 previous next