Filter
Top Products
SKU 91764 For technical questions, please call 1-800-444-3353. Page 6
WARNING: Do not overload this lift, which has a 1/2 Ton (1000 Lbs. capacity).
The lift may be damaged, and you may experience unplanned, rapid lowering of
the load. This may cause severe personal injury or property damage.
WARNING: Do not carry an unbalanced load, or a load not appropriate to the
designed use of this lift. The lift may topple over causing serious personal injury or
property damage.
Warning: With the lift in position and before the Motorcycle is on the lift, raise the
Casters (14) off the ground to prevent the lift from moving during use. Raise the
Casters by turning the Adjustment Screw (18) clockwise.
Operation
WARNING: Before standing or working underneath any elevated motorcycle, be
sure that the motorcycle is properly and safely secured. For your safety and the
safety of others, use good professional practice and common sense.
1) Position the lift in a safe, secure area. Be sure that the surface on which you
are working is level and solid, capable of supporting at least 1000 lbs.
2) With the Sliding Plate (36) in place, roll the motorcycle onto the lift. Kick the
center stand of the motorcycle down to stabilize it on the stand.
3) Clamp the front wheel of the
motorcycle into the Vise Assembly
to prevent movement of the wheel.
For maximum safety, you should also
stabilize the motorcycle using tie-down
straps (not included).
4) Pump the Lift Foot Pedal (11)
repeatedly to raise the lift.
5) When the platform has been
raised to the working height, pass the
Locking Bar (22) through the holes in
the Front Lifting Arm (38) so the lift
cannot be accidently lowered. You
may now perform maintenance on
the motorcycle.
6) When the work is completed,
check under the Lift to see that
there are no obstructions, and that
it is safe to lower the unit. Remove
the Locking Bar (22), then slowly
press the Release Foot Pedal (10)
to slowly lower the unit.
Vise Assembly
Locking Bar (22)
Adjusting Screw (18)
Caster (14)