Filter
Top Products
Page 15For technical questions, please call 1-800-520-0882.Vertical Engine
Troubleshooting
Problem Possible Causes Probable Solutions
Engine will not start MOWER ENGINE SPECIFIC:
1. Brake Handle not held or brake
cable not connected properly.
2. Mower on top of grass.
MOWER ENGINE SPECIFIC:
1. Make sure brake handle is held down
and brake cable is properly adjusted.
2. Start mower atop clear area free
of loose objects and grass.
FUEL RELATED:
1. No fuel in tank.
2. Low quality or deteriorated, old gasoline.
3. Carburetor not primed.
4. Dirty fuel passageways.
5. Carburetor needle stuck. Fuel
can be smelled in the air.
6. Too much fuel in chamber. This can be
caused by the carburetor needle sticking.
FUEL RELATED:
1. Fill fuel tank.
2. Use fresh 87+ octane unleaded gasoline.
3. Press priming bulb before starting cold engine.
4. Clean out passageways using fuel additive.
Heavy deposits may require further cleaning.
5. Gentlytapsideofcarburetoroat
chamber with screwdriver handle.
6. Turn Choke to RUN (OPEN) position.
Remove spark plug and pull the start
handle several times to air out the chamber.
Reinstall spark plug and set Choke to
CHOKE (START/CLOSED) position.
IGNITION (SPARK) RELATED:
1. Spark plug cap not connected securely.
2. Spark plug electrode wet or dirty.
3. Incorrect spark plug gap.
4. Spark plug cap broken.
5. Incorrect spark timing or
faulty ignition system.
IGNITION (SPARK) RELATED:
1. Connect spark plug cap properly.
2. Clean spark plug.
3. Correct spark plug gap.
4. Replace spark plug cap.
5. Havequaliedtechniciandiagnose/
repair ignition system.
COMPRESSION RELATED:
1. Cylinder not lubricated. Problem after long
storage periods.
2. Loose or broken spark plug. (Hissing noise
will occur when trying to start.)
3. Loose cylinder head or damaged
head gasket. (Hissing noise will
occur when trying to start.)
4. Engine valves or tappets
mis-adjusted or stuck.
COMPRESSION RELATED:
1. Pour tablespoon of oil into spark
plug hole. Crank engine a few
times and try to start again.
2. Tighten spark plug. If that does not work,
replace spark plug. If problem persists,
may have head gasket problem, see #3.
3. Tighten head. If that does not remedy
problem, replace head gasket.
4. Havequaliedtechniciandiagnose/
repair ignition system.
Follow all safety precautions whenever diagnosing or servicing the equipment or engine.