Filter
Top Products
GPSMAP 62 Series Quick Start Manual 9
Using Sight ‘N Go
NOTE: Sight ‘N Go is available only
with the GPSMAP 62s and GPSMAP
62st.
You can point the device at an object
in the distance, such as a bridge, lock
in the direction, and then navigate to
the object.
1. From the main menu, select Sight
‘N Go.
2. Point the device at an object.
3. Select Lock Direction > Set
Course.
4. Use the compass to navigate to the
object.
Attaching the Wrist Strap
1. Place the loop of the wrist strap
through the slot opening at the
bottom of the device.
2. Route the strap through the loop,
and pull it tight.
Attaching the Carabiner
Clip
1. Position the carabiner clip in the
slots on the mounting spine.
2. Slide the clip up until it locks in
place.