Filter
Top Products
1.3 LED Function
Bluetooth Status LED (Blue):
Blinking (Slowly) ---- Not connected to any Bluetooth devices.
Blinking (Quickly) ---- Connected to other Bluetooth device.
GPS Status LED (Green):
Blinking ---- GPS position is fixed
Steady light ---- GPS position not fixed
Battery Status LED (Red/Yellow):
Red ---- Battery power is critically low. Charge immediately.
Yellow ---- Battery is charging now.
LED off ---- Battery partially full or Battery is fully charged.
1.4 External Antenna
Basically, you don’t need external antenna to perform GPS positioning with BT-308 since
it already build-in active antenna. The only condition that you need external antenna is when
BT-308 unit can not “see” the sky, For instance, when you are in any environments that GPS
signal is blocked, the external GPS antenna will help to receive better GPS signal.
Plug the external antenna with MMCX connector to the plug on BT-308. Place the
magnetic external antenna on the roof of the car or an outdoor open-space, and make sure
place it in correct direction. That is, the side with magnetic is the bottom side, and the upper
side must face to sky in order to receive better signal.
Notice:
Hold the antenna connector while you plug the external antenna into the BT-308 or
unplug the external antenna from the BT-308. Do not pull the cable line.
2. Usage
2.1. For PDA which built-in Bluetooth (Example: iPAQ 3870/3970)
1. Switch the BT-308 power on.
2. Please refer to the user manual of PDA to enable the Bluetooth of PDA
connecting to the BT-308. Some PDAs may need the Bluetooth passkey, the
passkey is “2003”.