Filter
Top Products
2
Installation
27" Grill Cart Assembly
• Two 7/16" wrenches
• 3/8" wrench or socket
• Phillips head screwdriver
• Rubber or wooden mallet
• Gloves to protect against sharp edges
10-24 Nuts
Phillips
Head
Screws
#10 Washers
USE
8
EACH
•Locate the bottom/base panel and one side
brace.
•Place the front of the base towards you.
(The front side has 6 screw holes on each
side.)
•Select the caster with lock on the side.
•Place the caster below the front side of the
base, aligned with 4 screw holes.
•Place a side brace on top of the base at the
left side with screw holes aligned.
•Install 4 phillips head screws through the
caster into the base and through the brace.
•Secure screws with flat washers and nuts on
top of the brace. Do not tighten.
•Install the other caster to opposite end of
the brace following the same procedure.
Bottom Panel
1/4-20 x 1/2
Bolts
1/4 Washer
1/4-20 Nuts
USE
4
EACH
•Install front brace to base with 4 bolts and
washers through the top and secure with
nuts on the bottom. Do not tighten.
1/4-20 x 1/2
Bolts
1/4 Washer
1/4-20 Nuts
USE
8
EACH
•Install right side brace to the base by
installing 8 bolts and washers through the
top and secure with nuts on the bottom.
Again, do not tighten.
•Adjust brace alignment by tapping and
sliding until corners meet. Tighten all
screws.
CAUTION: The grill is extremely heavy. 2
people are required to lift and place the grill
onto the cart.
Tools
You Will
Need
Step 2:
Install
Casters
and Braces
to Base