Filter
Top Products
5
5. Place the suction cup on the windshield.
6. Flip the lever back, toward the
windshield.
7. Fit the bottom of your nüvi into the
cradle.
8. Tilt the nüvi back until it snaps into place.
9. Plug the other end of the vehicle power
cable into a power outlet in your vehicle.
Your nüvi should turn on automatically if
it is plugged in and the vehicle is running.
Step 4: Congure the nüvi
To turn on your nüvi, press and hold .
Follow the on-screen instructions.
Step 5: Acquire Satellites
Go outdoors to an open area, out of garages,
and away from tall buildings. Stop your
vehicle, and turn on the nüvi. Acquiring
satellite signals may take a few minutes.
The bars indicate satellite strength.
When the bars are green, the nüvi has
acquired satellites signals. Now you can
select a destination and navigate to it. For
more information about GPS, go to
www.garmin.com/aboutGPS.
Resetting the nüvi
If the nüvi stops functioning, turn the nüvi
off and on again. If this does not help, press
and hold for 10 seconds. The nüvi should
operate normally. You can also remove the
battery, and then reinstall it.