Filter
Top Products
17
Advanced Operation
Nav Mode
Navigating to a MAHP
1. Press NAV to select the Nav receiver.
2. Set the VOR frequency for the radial you are following to the MAHP as the Active channel.
3. Set the Standby channel to the appropriate VOR and note where a radial crosses the MAHP for your
runway. Press NAV a second time to “monitor” the Standby channel. A small “m” will replace the “s”.
4. The Active channel will drive the internal CDI (on the right side of the display) and the external CDI, if
installed.
5. The radial for the Standby channel you are monitoring will be shown in parentheses to the right of the
Standby channel.
6. Use the monitored Standby channel to note your location along the path to the MAHP. You will be at
the MAHP when the Standby channel displayed radial matches the target radial.