Filter
Top Products
9-12
Garmin GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. B
Foreword
Getting
Started
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
Index
9.2.1 Displaying and Operating Traffic
(TAS Systems)
The unit must be in operating mode for traffic to be displayed. The ability
to switch from standby to operating mode on the ground is especially useful for
scanning the airspace around the airport before takeoff.
Heading
Annunciation
Range Rings
Ownship
Position
Non-Threat
Traffic
Traffic Proximity
Advisory
Altitude Filter
Traffic Status Key
(Operate/Standby)
Figure 9-6 Traffic Page
9.2.1.1 Switching from Standby Mode to Operating Mode
The Traffic Page shows surrounding TAS traffic data in relation to the aircraft’s
current position and altitude without basemap clutter. Aircraft orientation is
always heading up unless no valid heading is received. The Traffic Status is
shown in the lower left corner and the Altitude Filter is shown in the lower right
corner.
1. While viewing the Traffic Page, touch the Traffic Status key
to select
Operate
.
2. To switch to Standby Mode from the Traffic Page, touch the
Traffic Status key to select Standby.
3. Touch the Altitude Filter key to change the altitude
volume.
4. Touch the Traffic Status key to place the system in the Standby
mode. Standby is displayed in the Traffic mode field.
NOTE: Not all TAS systems can be set to “Standby” mode while in the
air.