Garmin 600 GPS Receiver User Manual


 
Rino600SeriesQuickStartManual 5
4. Charge the device completely.
A fully charged battery can run for
up to 14 hours before it must be
recharged.

Instead of the lithium-ion battery pack,
you can use alkaline, NiMH, or lithium
batteries. This is especially handy
when you are on the trail and cannot
charge the lithium-ion battery pack.
Use NiMH or lithium batteries for best
results.
1. Turn the D-ring counter-clockwise,
and pull up to remove the cover.
2. Insert four AA batteries, observing
polarity.
3. Replace the battery cover, and turn
the D-ring clockwise.


It may take 30 to 60 seconds to acquire
signals.
1. Go outdoors to an open area.
2. Turn on the device.
3. Wait while the device searches for
satellites.
A question mark ashes while the
device determines your location.
4. Select to open the backlight
status page.
The GPS bars indicate satellite
strength. When the bars are green,
the device has acquired satellite
signals.