Filter
Top Products
5. INITIAL SETTINGS
14
DATA 2 output setting
1) Press [MENU], [9] and [4]. The DATA 2 OUTPUT SETUP menu appears.
Talker ID GP LC DE
Output Data (00-90 sec) 100%
DATA2 OUTPUT SETUP
MENU : Escape
ENT : Enter
Data Fmt.
V1.5
: Select
Setting shown here are default settings.
1. AAM:00 APA:00 APB:04 BOD:00
2. BWR:00 BWW:00 GGA:00 GLL:01
3. RMB:01 RMC:00 VTG:01 WCV:00
4. VDR:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 GBS:01 Rnn:00 RTE:00
V2.0
IEC
Figure 5-4 DATA 2 OUTPUT SETUP menu
2) Follow the procedure for setting DATA 1 output.
DATA 3 output setting
The DATA 3 can output NMEA 0183 (V1.5/V2.0) /IEC 61162-1 data or log pulse by
selecting inner jumper wires. For NMEA 0183 (V1.5/V2.0) /IEC 61162-1, the same signal of
DATA 1 is output from DATA 3.
Selection of NMEA0183 or log pulse
Output data
NAV board
NMEA 0183 (V1.5/
V2.0)/IEC 61162-1
(default setting)
Log pulse
JP4 (2 pcs.) ON OFF
JP5 (3 pcs.) OFF ON
Rate of log pulse output
500 mA Max.
50 VDC
Procedure for setting of log pulse rate
1) Press [MENU], [9] and [3].
2) Press
S or T to select DATA 3. Log Pulse.
3) Press
W or X to select log pulse for external equipment; 200 ppm or 400 ppm.
4) Press the [ENT] key.
5) Press the [ESC] key.