Filter
Top Products
3-1
MENU OVERVIEW
The menu system consists of four menus: Scan menu, Menu-1,
Menu-2, and System. The Scan menu can be opened while trans-
mitting, and contains items which the user will often change
during the course of operation. Menu-1 (similar to the Scan
menu), Menu-2 and System menus can be opened with the trans-
mitter turned off. Menu-2 and the System menus contain items
which once set do not require frequent adjustment.
Scan Menu Operation
Displaying the scan menu
1. Press the TX switch to light the lamp (transmitter on state)
above it, if it is not already lit.
2. Press the MENU key. The first five items of the Scan menu
appear. (The figure below shows the entire menu.)
**SCAN MENU ** (RANGE SW: U/D GAIN SW: L/R)
DEGAUSS
AUTO DEGAUSS
DISPLAY MODE
TX OUTPUT
PULSELENGTH
TX CYCLE
TVG NEAR
TVG FAR
AGC
NOISE LIM
VP
IR
MARK ERASE
HOR BEAM ANGL
RES COL CURVE
COLOR EMPHASIS
FUNC1 PROG
FUNC2 PROG
USER PROG
: EXECUTE
: OFF
: NORM
:10
:10
:10
:10
:10
:10
:10
: 0
: 0
: COURSE
: WIDE
: LINEAR
: 1 (LOW)
: USER1
: USER2
: USER1
TIMER
TEXT
SHIP
NARROW
1
2
SETUP1
SETUP1
USER2
GYRO
2
3
SETUP2
SETUP2
3
4 (HIGH)
SETUP3
SETUP3
#
#
#
Requires INTERFACE Board.
# Locked setting (in red). To change, select item, adjust GAIN control to
display YES, and press the TX key. Selected item appears in green;
setting may now be changed.
Figure 3-1 Scan menu