Filter
Top Products
3
Press to ARM
the Security System
and Lock Doors
Press for Car Finder
Press and Hold for
Panic Alarm
Press to DISARM
Security System and
Unlock Drivers Door
(or all doors depending
to installation option**)
Press Again to Unlock
All Doors**
Press and Hold To
Open Trunk or Hatch**
Press to activate
Headlight control
Remote Control Operation
Arming the Security System
Using the PowerCode Remote Control Transmitter:
Press* the button on the PowerCode remote control transmitter. The system will
lock the doors and flash the parking lights two times to indicate that the security
system has armed. If the button is pressed a second time within 5 seconds, the
system will chirp the horn two times confirming that the system has armed.
Using the factory supplied Keyless Entry Remote control:
Press* the button on the factory RKE keyfob. When the factory keyless system
locks the doors, the PowerCode system will flash the parking lights one time, pause
for 15 seconds and then flash the parking lights two more times to indicate that the
security system has armed. To override the 15 second arming delay, press the
button on the factory RKE keyfob a second time within 5 seconds of the first press.
The PowerCode security system can also be armed by pressing the “Lock” button on
either front door or the 7/8 and 9/0 buttons together on the outside door mounted
keypad.
Note: To lock the vehicle’s doors without arming the security system, press “Unlock”
then “Lock” on either the factory RKE keyfob or door mounted lock/unlock switch. If
desired, your PowerCode system can be programmed to only arm when locking the
doors using the PowerCode remote control transmitter.
Your PowerCode system’s security functions can be controlled using either the
supplied PowerCode systems remote control transmitter or the vehicle’s factory RKE
keyfobs (if equipped). Also note, that the PowerCode system, while integrated, with
the factory RKE system, does not alter the functionality of the factory RKE system in
any way.
QUICKSTART
* “Press” refers to pushing a transmitter button for approximately one second.
** Optional installation feature, see your dealer for details.