Filter
Top Products
administrative privileges. When you restart the engine, the vehicle will
identify the user as an admin or MyKey™ drive depending on the
settings of the actual key used to start the vehicle.
Note: For all vehicles, the number of MYKEY(S) PROGRAMMED or
ADMIN KEYS PROGRAMMED that is displayed in the MyKey™ system
status menus will include the non Ford-approved remote start system as
an additional key in the total count. See the Check MyKey™ system
status section.
Note: For all vehicles with a non Ford-approved remote start installed, it
is possible to program all ’real’ keys as MyKeys™, in which case, you will
need to use your remote start system to reset all MyKeys™ as admin
keys by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your non Ford-approved remote start
fob.
3. Follow Steps 1-4 in the Clear MyKey™ section.
Troubleshooting
Condition Potential Causes
Can’t create a
MyKey™
• Key in the ignition is already a MyKey™.
• Key in the ignition is the last remaining admin key
(there always has to be at least one admin key).
• Intelligent access key (if equipped) is not in the
backup slot (for vehicles with push button start).
• SecuriLock passive anti-theft system is disabled
or in unlimited mode.
• Vehicle has been started using a non
Ford-approved remote start system that is
programmed as MyKey™. Refer to Using MyKey™
with remote start systems section.
Cannot program
the MyKey™
optional settings
• Key in the ignition is a MyKey™.
• No MyKeys™ are programmed to the vehicle.
Refer to Create a MyKey™ section.
• Vehicle has been started using a non
Ford-approved remote start system that is
programmed as MyKey™. Refer to Using MyKey™
with remote start systems section.
Locks and Security
124
2011 Edge (edg)
Owners Guide, 1st Printing
USA (fus)