Filter
Top Products
To power close the liftgate with
the rear cargo area control
button:
Press and release the control on the
left rear quarter panel to close the
liftgate.
Note: The rear cargo area control
button is disabled when the liftgate
is latched (fully closed).
WARNING: Keep clear of the liftgate when activating the rear
switch.
Note: The liftgate movement direction can be reversed with a second
press of the instrument panel, or the rear cargo area control buttons, or
a second double press of the integrated keyhead transmitter button.
To manually operate the liftgate:
1. Disable the liftgate power function. Refer to the Message center in
this chapter.
2. Open and close the liftgate as you would a standard liftgate. Refer to
Manual liftgate in this chapter.
Note: In case of operation in extreme cold -40°F (-40°C), or on extreme
inclines, manual operation of the liftgate is suggested.
Obstacle detection:
The power liftgate system is equipped with an obstacle detection feature.
If the power liftgate is closing, the system will reverse to full open when
it detects an obstacle. A chime will sound three times when an obstacle
is detected as the liftgate begins to reopen. Once the obstacle is
removed, the liftgate can be closed under power.
If the power liftgate is opening, the system will stop and a chime will
sound three times when an obstacle is detected. Once the obstacle is
removed, the liftgate can again be operated normally.
Resetting the power liftgate:
The power liftgate may not operate properly and may need to be reset if
any of these conditions occur:
• a low voltage or dead battery
• disconnected battery
Driver Controls
123
2010 Flex (471)
Owners Guide, 1st Printing
USA (fus)