Filter
Top Products
Changing the air filter element (except Bullitt™* Mustang)
1. Release the clamps that secure
the air filter housing cover.
2. Carefully separate the two halves
of the air filter housing.
3. Remove the air filter element
from the air filter housing.
4. Wipe the air filter housing and
cover clean to remove any dirt or
debris and to ensure good sealing.
5. Install a new air filter element. Be
careful not to crimp the filter element edges between the air filter
housing and cover. This could cause filter damage and allow unfiltered
air to enter the engine if not properly seated.
6. Replace the air filter housing cover and secure the clamps. Be sure
that the air cleaner cover tabs are engaged into the slots of the air
cleaner housing.
*™& Warner Bros. Entertainment Inc. (s07)
Changing the air filter element (Bullitt™* Mustang)
1. Remove the two screws that hold
the air filter assembly to the air
filter tray.
2. Lift the air filter element
assembly out from the air filter tray
by pulling it up and left slightly to
clear the retaining tab.
3. Loosen the air filter clamp bolt
enough to allow the air filter to slip
off the air filter tube easily.
4. Slip the air filter off from the air filter tube.
5. Install the new air filter by reversing Steps 1–4.
*™& Warner Bros. Entertainment Inc. (s07)
Note: Failure to use the correct air filter element may result in severe
engine damage. The customer warranty may be void for any damage to
the engine if the correct air filter element is not used.
2009 05+ Mustang (197)
Owners Guide
USA (fus)
Maintenance and Specifications
277