Filter
Top Products
Method #3 - By Identification Number
Certain parts and most major assemblies are identified with an “identification” number (sometimes
an engineering or casting number) shown on an attached tag or plate or on the part itself.
Reference to identification numbers is made throughout the catalog and cross reference charts
are included in some
sections to provide
immediate knowledge of
the service part number
when the identification
number is known.
For example, on page 4 of
“Section 40 – Rear Axles,
Drive Shafts” contains
information about
Identification Tags for a
Rear Axle.
Using the ID will provide
valuable information. For
example, a WDL-W-1 for
a 66/69 was 3.00 with a
28 spline shaft.
The ID code is also useful
in determining the correct
part number as shown in
this example.