Filter
Top Products
8
P5920pr-0920
BOTTOM VIEW
1
BATTERY CHARGING
Charger
Connector
A
B
• Plug the charger connector into the battery
A
.
• Plug the charger into a standard wall outlet. The power
indicator lights
B
.
Notes:
- If power flow to the wall outlet is controlled by a switch,
make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
- The power indicator on the charger does not indicate the charge
status of your battery. The power indicator allows you to see
that there is power from the wall outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of
your vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the battery connector
from the charger connector. Unplug the charger from the wall
outlet. The battery is now ready to be installed in your vehicle.
Please see the Battery Installation section on page 18 for
detailed instructions on installing your battery. If your battery
is already installed in your vehicle, simply re-connect the motor
harness connector to the battery.
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
• Place the vehicle upside down.
• Slide the bumper support, ribbed side up, into the slot in the
front end of the vehicle.
• Insert two ¼ " x 1¼ " screws into the bumper support and tighten.
Bumper Support
ASSEMBLY
Power
Indicator
CAUTION
• In the unassembled state, this package
contains small parts. Adult assembly
is required.