Filter
Top Products
12
P5065a-0920
3
• Fit the tabs on the front of the seat into the slots in the vehicle.
• Push down on the seat to “snap" in place.
Seat
4
2
• Replace the screw in the holes on each side of the seat
and tighten.
• Replace the battery retainer in the battery compartment.
• Insert the screw into the hole in the battery retainer and tighten.
BATTERY INSTALLATION
IMPORTANT! Use only a Power Wheels
®
6 volt lead-acid
rechargeable battery. Use of any other battery will damage your
vehicle. Make sure that you charge the battery for at least
18 hours using the enclosed Power Wheels
®
6 volt charger before
operating your vehicle for the first time. Charge the battery for
at least 14 hours after each use of the vehicle. Never charge the
battery longer than 30 hours. Failure to follow these instructions
may damage your battery and will void your warranty.
1
• Plug the motor harness connector into the battery connector.
Push firmly.
• Place the battery upright in the battery compartment.
6 Volt Battery
INCORRECTCORRECT
Battery Retainer
Motor Harness Connector