8
P2896pr-0920
Insert two screws into the dash assembly. Tighten •
the screws.
Fit the steering column assembly down through the •
opening in the dash.
Apply label exactly as shown in the illustration. Avoid •
repositioning the label after it has been applied.
At an angle, fi t the tabs on the dash assembly into the •
slots in the vehicle.
Dash Assembly
Steering Wheel Assembly
Carefully turn the vehicle on its side. •
Fit the end of the steering column through the hole in •
the steering linkage.
Fit the steering column cap onto the end of the •
steering column.
Insert a screw into the hole in the steering column cap. •
Tighten the screw.
Turn the vehicle upright.•
Steering
Column Cap
ASSEMBLY
6
10
11
7
9
8
BACK VIEW
Screws
BOTTOM VIEW
Screw
20
INSIDE VIEW