Filter
Top Products
M7873pr-0920
8
• Carefully turn the vehicle upside-down.
• Again, make sure the end of the steering column is through
the hole in the steering linkage.
• Fit the steering column cap onto the end of the
steering column.
• Insert the #8 x
3
/4" screw through the large opening in the
steering column cap and through the hole in the steering
column. Tighten the screw.
4
• Slide the steering column clip under the steering column, as
shown, and push to "snap" in place.
• Turn the vehicle upright.
5
• Fit BOTH handle pieces onto the handle base on the dash of
the vehicle.
Note: The handle pieces are designed to fit one way. If either
piece does not seem to fit on one side of the handle try the
other side!
• Insert the #6 x
1
/2" screw into the handle assembly and tighten.
6
Steering
Column Cap
Handle Pieces
Steering
Column Clip
• Push down on the handlebar assembly to "snap" it in place.
3
Push
BOTTOM VIEW
Handlebar Assembly
DASH VIEW