Filter
Top Products
8
TABLE OF CONTENTS
A
M5130pr-0920
• Plug the charger into a standard wall outlet.
Notes:
- Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
- If the power flow to the wall outlet is controlled by a switch,
make sure the swtich is "ON."
- The power indicator on the charger does not indicate the charge
status of your battery. The power indicator allows you to see
that there is power from the wall outlet to the charger.
• Before first time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery after each use of your vehicle for at least
14 hours. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector
from the battery connector. Unplug the charger from the
wall outlet. The battery is now ready to be installed in your
vehicle. Please see “Battery Installation” on page 15 for
detailed instructions on installing your battery. If your battery
is already installed in your vehicle, simply re-connect the
battery connector and motor harness connector and replace the
bumper cover (battery retainer).
8
BATTERY CHARGING
E
M5130pr-0920
IMPORTANT! The battery must be removed from your vehicle
for the initial charge in order to complete assembly. After
assembly is complete, you do not need to remove the battery
from your vehicle to recharge it.
1
• Loosen the screw in the rear bumper cover (battery retainer).
• Remove the rear bumper cover.
Bumper Cover
(Battery Retainer)
4
2
• Lift to remove the battery from the battery compartment.
6 Volt Battery
Battery
Connector
• Plug the battery connector into the charger connector.
3
Charger
Connector