Filter
Top Products
H7332pr-0920
3
IMPORTANT! Use only a Power Wheels
®
6 volt battery with A-style
connector and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
®
Super 6 volt
charger before operating your vehicle for the first time. Charge the
battery for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow these
instructions may damage your battery and will void your warranty.
• Squeeze the battery retainer arms together to release them from the
slots in the vehicle.
• Press the battery retainer arms in and over the lock tabs and lift the
battery retainer.
• Lower the battery retainer over the
battery and foam spacer.
• Fit the battery retainer arms down into the slots in the vehicle.
• Press the battery retainer arms out over the lock tabs to snap and
secure the battery retainer arms in the slots.
• Replace the vehicle seat.
• Place the battery upright in the battery compartment.
• Place the foam spacer in the battery compartment, behind the battery.
• Plug the battery connector and motor harness connector together.
Push firmly to make sure the two connectors are completely joined.
12
BATTERY INSTALLATION
H
J7826a-0920
Seat
Tab
1
• Press the tab under the back of the seat and lift to remove the seat.
Battery
Retainer Arms
Slot
Slot
2
Battery
Motor
Harness
Connector
Arm
Arm
Slot
Slot
GAP NO GAP
INCORRECT CORRECT
Battery
Connector
4
Foam Spacer