Filter
Top Products
19
N1476pr-0920
• Check all screws, cap nuts and their protective coverings
regularly and tighten as required. Check plastic parts on a
regular basis for cracks or broken pieces.
• During snowy or rainy weather, the vehicle should be stored
inside or under a protective cover. Remember to charge the
battery at least once per month while your vehicle is not in
regular use.
• Avoid operating the vehicle in wet or snowy conditions, and do
not spray the vehicle with a hose. Do not wash the vehicle with
soap and water. Water or moisture in the motors or electrical
switches can cause them to corrode, and could cause switch
or motor failure.
• Avoid operating the vehicle on sand, loose dirt or gravel.
Sand, loose dirt or gravel in the motors or electrical
switches can cause them to jam, and could cause switch
or motor failure.
• The vehicle can be wiped down with a soft, dry cloth.
For a shiny finish, you can wipe plastic parts with a non-
wax furniture polish applied to a soft-cloth. Do not use
automotive wax.
• To ensure that your vehicle stays in good operating order, we
recommend that you periodically have your vehicle checked by
a Power Wheels
®
authorized service center. For the location of
the authorized service center nearest you, please visit us on-
line at www.powerwheels.com or call 1-800-348-0751.
VEHICLE CARE
L
VEHICLE OPERATION
K
To Drive
• Make sure the shifter is in the high speed
position
1
.
• Press down on the foot pedal
2
. The vehicle goes forward
at a maximum of 5 mph
3
. Help your child practice steering
to learn how far and how quickly to turn the steering wheel
when driving forward in high speed.
1 2
3
Advanced Use - High Speed Drive
• Before you disconnect the high speed lock-out, make sure
your child knows how to steer, how to start and stop the
vehicle and knows the rules for safe driving. When the high
speed lock-out is disconnected, the vehicle can be driven
forward in low speed (2
1
/2 mph, maximum) or high speed
(5 mph, maximum).
• Make sure the shifter is in the reverse position.
• Loosen and remove the screw in the shifter base.
• Replace the lock-out screw into the storage position hole in
the shifter for future use. It can be re-inserted into the shifter
base to lock-out high speed.
Storage Position
Storage Position
Shifter
Shifter
Lock-Out Screw
Lock-Out Screw