Filter
Top Products
• Turn the vehicle on its side.
• Insert two #10 x
1
/
2
"
screws into the holes in the
underside of each rear wheel well, through the vehicle
body and into the ends of the sport bar.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Rear of
Vehicle
36
Bottom View
Assembly
• Fit a sport bar support to one side of the sport bar.
• Insert a #8-32 x 1.625
"
screw through the sport
bar support, the sport bar and out through the sport
bar support.
• Fit a lock nut to the end of the screw.
• While holding the lock nut with the pliers, tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to attach the other sport bar support
to the sport bar.
Sport Bar
Sport Bar
Supports
33
18
• Fit the sport bar assembly into the holes in the
vehicle body.
• Push down firmly on a sport bar support while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
Side
Fender
PULL
HERE
PUSH
HERE
35
• Fit the light covers to the lights on the sport bar, as shown.
• Insert a #10 x
1
/
2
"
screw through the light cover and into
the light. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Light
Cover
Light
Cover
Lights
34