Filter
Top Products
13
Assembly
2
1
Battery
Compartment
Dash
• Position the dash on the vehicle body.
• Make sure the motor connector is through the groove in
the dash.
• Insert a #10 x
1
/2" screw through each of the two corner
dash tabs nearest to the passenger compartment .
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment .
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip .
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Battery Clamp
Motor
Connector
14
Light Wire
Wire Clip
• Fit the light wire into the wire clip.
12
Light Wire
Connector
Sound and Light Unit
Wire Connector
• Plug the sound and light unit connector into the light wire
connector. Push firmly to make sure the connectors are
completely joined.
13
Dash
Key Assembly
• Insert and “snap” the key assembly into the opening in
the dash, as shown.
15