Filter
Top Products
Battery Installation
H
Important Note: Use only Power Wheels
®
Type H batteries
with Power Wheels
®
30 amp fuses installed. Use of any
other batteries or fuses will damage your vehicle. Make
sure that you charge the batteries for at least 18 hours
using the enclosed Power Wheels
®
12 volt charger before
operating your vehicle for the first time. Charge the
batteries for at least 14 hours after each use of the
vehicle. Never charge the batteries longer than 30 hours.
Failure to follow these instructions may damage your
batteries and will void your warranty.
1
2
3
• Lift the hood to access the battery compartment.
• Place both Power Wheels
®
Type H batteries upright in
the battery compartment. Make sure the battery
connectors extend toward the front of the vehicle.
• Make sure a Power Wheels
®
30 amp fuse in good
condition is installed in each of the batteries and that the
battery connectors are snapped together.
• Insert the looped end of the battery retainer ( ) into the
slot in the vehicle body near the dash.
• Squeeze the battery retainer arms ( ) and fit them into
the slots in the vehicle body.
Battery
Compartment
Hood
• Squeeze the tabs on each side of the motor harness
connector.
• Plug the battery connector into the motor harness
connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
4
18
1
2
Motor Harness
Connector
Battery
Connector
Slots
Hole
Prongs
Small End
1
2
Battery
Retainer
Power Wheels
®
Type H Batteries
Battery
Connector
Front of Vehicle
Power Wheels
®
30 Amp Fuses