Filter
Top Products
• Locate the battery compartment on the lights and siren.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver. The screw will remain in the door.
• Lift the battery compartment door to open it.
• Insert four size “AA” (LR6) alkaline batteries as
indicated on the battery compartment door.
+
-
1.5V x 4
“AA” (LR6)
Shown Actual Size
Battery
Compartment
Door
Lights and Siren
22
Lights and Siren
Speaker
Front of Hood
Lights and
Siren Cord
23
• Insert the lights and siren cord through the hole in the
center of the hood.
• Fit the lights and siren to the top of the hood. Make sure
the speaker faces the front of the hood.
• Insert two #6 x
7
/
16
" screws with washers through the
holes in the underside of the hood and into the lights and
siren. (The #6 x
7
/
16
" screws and #6 washers can be found
in the small parts bag enclosed with the lights and siren
and microphone.)
Battery Tips:
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Battery leakage and corrosion can cause damage.
Dispose of batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in the “Battery Installation” instructions
are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
product before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
Assembly
17
• Fit the back half of the windshield frame onto the front half
of the windshield frame. Make sure the slots at the bottom
of the two windshield frame halves are aligned.
• Insert ten #8 x 1
1
/
4
" screws into the back half of the
windshield frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Helpful Hint: Squeeze the two windshield halves together
while tightening the screws.
• Lift the assembled windshield to the raised position.
Slots
Windshield Frame –
Front Half
Windshield Frame – Back Half
21
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.