Filter
Top Products
• Loosen the screw in the battery clamp and remove it.
6 Volt
Battery
Battery
Compartment
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener
1
/4 turn
to the unlocked position .
• Lift the seat from the vehicle.
Battery
Clamp
Battery
Clamp
Battery
Lock
Fastener
Seat
• Fit the Power Wheels
®
6 volt (4.0 Amp/Hr) battery inside
the battery compartment with the wires facing towards
the rear of the vehicle.
• Place the battery clamp over the battery.
• Replace the screw through the end of the battery clamp
and into the vehicle body.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Battery Installation
H
2
1
3
4
12
IMPORTANT! Use only a Power Wheels
®
6 volt (4.0 Amp/Hr)
battery with a Power Wheels
®
25 amp fuse installed. Use
of any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
®
6 volt charger before operat-ing
your vehicle for the first time. Charge the battery for
at least 18 hours after each use of the vehicle. Failure to
follow these instructions may damage your battery and will
void your warranty.
Locked
Unlocked
Little Kawa 9/20/02 1:36 PM Page 12