Filter
Top Products
14
• Turn the vehicle on its side.
• Fit a traction band around a wheel.
• Slide a slotted screwdriver under the traction band to
push the traction band onto the ridge in the center of
the wheel.
Helpful Hint: If the traction band is difficult to fit around
the wheel, you may want to soak it in warm water to soft-
en it slightly.
• Repeat this procedure to assemble a traction band to
each wheel.
Traction
Band
Wheel
Ridge
24
• Snap the center of the spark plug wire set onto the
pretend engine.
• Fit each of the spark plug wire ends into the holes on the
sides of the pretend engine.
Important Note! You must install your Power Wheels
®
battery in your vehicle before assembling the pretend
engine under the hood. Please refer to “Battery
Installation” on page 16 for detailed instructions.
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Pretend
Engine
25
Bottom View
Assembly