Filter
Top Products
• Insert #8 x
5
/
8" trusshead shoulder screws through the
holes in the steering linkage.
• Fit a round washer on the end of each screw.
• Insert one of the screws (with washer) into the screw
peg on the rear axle support. Insert the other screw
(with washer) into the hole in the motor assembly.
• Tighten the screws with a Phillips screwdriver but do
not over-tighten. It is important that the screws not
restrict movement of the steering linkage.
7
Assembly
• Position the vehicle body upside down.
• With the cupped side of the rear axle support facing up,
fit the holes in the rear axle support onto the screw pegs
on the vehicle body.
Rear Axle
Support
Hole
Hole
Screw
Peg
Screw
Peg
Bottom View
Bottom View
4
• Fit the two metal washer plates onto the vehicle body
screw pegs extending through the rear axle support.
• Insert a #8 x
7
/
8" trusshead screw through each metal
washer plate and into the vehicle body.
• Tighten the screws with a Phillips screwdriver but do not
over-tighten. It is important that the metal washer
plates move freely under the screws.
Metal
Washer
Plate
Metal
Washer
Plate
Screw
Peg
Screw
Peg
Rear
Axle
Support
Bottom View
5
6
Steering
Linkage
Rear Axle
Support
Screw
Peg
Washer
Washer
Motor
Assembly
74240a-0920 pgs. 6-12 3/5/01 8:33 AM Page 2