Filter
Top Products
13 By Firstech, LLC By Firstech, LLC 12
General System Functions
Only available with CS600-S / AR600-S Remote start only system.
Timer start mode is used to cool or warm the vehicle without manually starting with the key or from the remote. While engaged, timer
start will activate even while the remote is out of range. Hold buttons simultaneously for 2.5 seconds to activate timer start mode.
Timer start mode will be cancelled any time the vehicle is started manually or remotely. To change from the default setting to optional
settings, see your local Firstech dealer.
Default 1: Will start every 3 hours for a 24 hour cycle, or until the vehicle is remote started or started by key, and run for whatever your remote start
run time is set for.
Option 2: Will start every 1.5 hours for a 24 hour cycle, or until the vehicle is remote started or started by key, and run for whatever your remote start
run time is set for.
t@s@m
Only available with CS600-A alarm only system
Drive Lock/Ignition Controlled Door Locks all your power door locks after the vehicle is started and 30 seconds have passed. The door lock will unlock
when you turn the vehicle’s key off. You also have the option for the doors to only lock or only unlock.
This may require additional parts labor.
d@l@O@@c@d@l
Remote Coding / Programming Routine
p@VPPr
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds. The
vehicle’s parking lights will flash once with the successful completion of this step.
STEP 2: Within a second after cycling the ignition for the 5th time, tap the Lock button once for 0.5 second. The parking lights will flash once to confirm the
transmitter has been coded.
Programming Multiple Remotes: After the confirmation flash given in STEP 2, code additional remotes by
pressing the single button on remote. The parking lights will flash once confirming each additional remote. The CM-600
and CM-1300 can store up to three remotes.
Exiting Programming: Programming is a timed sequence. If you can not get the remote(s) to program then the
system enters Valet Mode. The parking lights will flash twice signaling the end of programming
IMPORTANT: The 600R remotes are preprogrammed to your system. In the even you need to program your remotes follow this simple procedure below.